440.800M

Steep Taper Tool Changer Alignment Gauge Instruction Manual

The tool changer alignment gauge is designed to verify correct alignment of the machine spindle to the tool changer. See PDF for full instruction manual.

PDF Data Sheet: Steep Taper Tool Changer Alignment Gauge Instruction Manual (440.800M)

OverviewThe tool changer alignment gauge is designed to verify correct alignment of the machine spindle to the tool changer. The gauge consists of three pieces as shown in the diagram. Also included (not shown) is a screw to hold the taper when it is installed in the spindle.

Steep Taper Tool Changer Alignment Gauge Instruction Manual

WARNING: Be sure appropriate steps have been taken to ensure the machine is safe to work on before proceeding.
1. Clamp the taper in the spindleInstall a retention knob appropriate to the machine into the taper. Using the included screw to hold the taper, clamp the taper into the machine spindle as you would any other tool. Once clamped, remove the screw.

2. Insert the flange into the tool changer gripperWith the flange held in the tool changer gripper, move the tool changer mechanism in close proximity to the spindle. The groove in the bottom of the flange allows the tool changer gripper to move freely relative to the spindle.

3. Insert the pinAdjust the tool changer and/or spindle as needed. When the pin passes through both the flange and taper, the tool changer and spindle are axially aligned. Next, verify that the Flange and Taper faces are parallel and flush to each other.

4. Radial alignmentTo align the tool changer radially relative to the spindle drive keys, rotate the spindle or tool changer gripper assembly (depends on machine design). Once the notches on the flange contact the spindle drive keys as shown to the right, the spindle is aligned radially relative to the tool changer.


See PDF data sheet for further instruction and diagrams.


Was this information helpful? Provide feedback or ask a quick question about this item.


Your name:
Your company:
E-mail:

For more information regarding this item (Steep Taper Tool Changer Alignment Gauge Instruction Manual) or other items, fill out the form below or contact our office directly:

Telephone: 815-962-5600
Fax: 815-962-4600
Location: 304 North Main St, Suite 104, Rockford, IL 61101-1101 USA
Email: infο@ΤΑCRοckfοrd.cοm

Add Comment

Alias

Full name
Position/Title
Company
Telephone
Fax
Email
Mailing Address

Receive a quote or more information on:


Questions or comments:


How did you hear about us?
   Other:


Your preferred method of contact

Related

Steep Taper Tool Changer Alignment Gauges
Steep Taper Tool Changer Alignment Gauges

Available for Steep Taper 30, 40, 50, and 60. Includes padded storage case.

Page loaded in 0.0728 seconds.